With the exception of the top sheet, all other parts of the set must have a toner-free margin at the gluing edge of at least 1/32". This will ensure problem free gluing.  Collated sets should be carefully jogged to produce a perfectly smooth gluing edge.  This will allow for even glue penetration of the specialized laser carbonless paper glue into the coatings.  The forms should be handled carefully to avoid damage from excess pressure.  We recommend to carry out a trial on a small stack of forms to establish both the recommended amount of adhesive application and correct drying time.
 

Shake the Fanapart Adhesive before use.  A small amount of adhesive should be poured into a small non-metallic container.  The stack height for gluing should not exceed 11 3/4" and a waterproof board should be placed on top.  A weight of 2.2 - 4.4 lbs placed on top is also recommended.  The glue should be applied generously with a 2" soft bristled brush using horizontal strokes until the gluing edge is uniformly glossy.
 

Separation of the sets should be carried out by lateral sliding of the sets.  This separation should take place after 30 minutes.  We do not recommend the use of heaters to accelerate drying.  Complete drying/bonding is complete after 2 - 3 hours after gluing.  The forms are now ready for use.

For more information click here.
Or call 1-800-777-7359 or email us at information@laser-forms.com.

Home • About Us •  Search • Site Map • Request Info • Contact Us